|
Post by umpossible on Mar 27, 2017 18:45:29 GMT
Hey everybody, So I got my hands on Kallus2 and azeral over the weekend and I was pleasantly surprised with how well/easy those models went together. Honestly, it was fun again to build the models. Is anyone else having a great time building Kallus 2 and azeral?
|
|
|
Post by shroomvolcano on Mar 28, 2017 19:14:31 GMT
I couldn't for the life of me get Kallus' front right centaur leg to stay on and had to end up pinning it, but Azreal went together like a dream.
|
|
|
Post by cainuslupus on Mar 28, 2017 22:55:45 GMT
I love to hear that. I decided to not buy either of them dreading they will be nightmare to assemble.
|
|
eauc
Junior Strategist
Posts: 209
|
Post by eauc on Mar 29, 2017 13:02:02 GMT
The pro : - easy to assemble. - the mix of platics & metal means it's easier to pin all pieces... at least on the plastic half. - Azraek was easy to fully magnetize. I made it so that I can remove the wings, the hand with the spear, and the spears in the back. It was quite easy. All the joints are big enough to use d3x2mm magnets, that hold the pieces together pretty well. The cons : - the mold on Kallus body was offset by nearly 3mm in my case. - the mold marks on every piece of Azrael were really important. - the wings of Azrael were very thin, almost transparent - and they bend really easily, but not in a very reassuring way... Still the same problems with PP's resin
|
|
|
Post by shroomvolcano on Mar 29, 2017 14:52:47 GMT
The cons : - the mold on Kallus body was offset by nearly 3mm in my case. - the mold marks on every piece of Azrael were really important. - the wings of Azrael were very thin, almost transparent - and they bend really easily, but not in a very reassuring way... Still the same problems with PP's resin Azrael's wings are definitely super bendy, transport might be tough (I def should've magnetized them). That sucks that your mold lines were so much more prevalent, I didn't have any bad ones on either of them, just the sprue bits that needed clipped off and shaved flat. I was actually pretty impressed with it.
|
|
|
Post by ForEver_Blight on Mar 29, 2017 15:01:22 GMT
Just got Azrael out of the mailbox yesterday. Wings are transparent in places but assembly was the best winged model by far. I was pretty happy with him.
Complaint - sprue like bits on very flimsy wing tips. Dared not cut them off clean with an xacto so had to use clippers and that scars the plastic annoyingly. Worse though was the two on his tail. They tore out material when i cut them off with clippers. Or there were bubbles in the mold around those points. I had to fill it in and smooth it back out. Made me a bit mad as I don't think that should have happened.
|
|